JLT Series 2 Intake system for the 2010 V6 in black textured plastic finish.
Though our original JLT Intake was a huge success, we have pushed the envelope and did a complete redesign from top to bottom in March 2012 and now have the JLT Series 2 CAI for the 2010 Mustang V6.
JLT Series 2 Intake DESIGN
The JLT Series 2 tube is 3 1/2″ ID, roto molded plastic to resist engine heat and keep the intake air charge nice and cool. NO METAL TUBING HERE!!
With no separate MAF housing or couplers air flow is fast and smooth.
MOLDED IN MAF
All Series 2 tubes have a 84mm MAF molded right in the tube.
We have seen gains of 10-15 RWHP with the 93 octane tune.
A JLT Series 2 tune is REQUIRED for this kit.
The new design and detailed instructions help make this an easy install (see Instructions tab to download).
Fits 2010 Mustang V6’s
• JLT Plastic Intake Tube
• Rubber Elbow
• 3.5×8″ S&B Powerstack Air Filter
• ABS Heat Shield
• PCV hose
• HD Clamps & all needed hardware
To properly clean your oil filter, we recommend the S&B Precision II Cleaning & Oiling Kit.
*TIP* by purchasing a 2nd air filter you can simply swap filters when it’s time to clean it and not be rushed. Clean the first filter and it’s ready when it’s time to change again.
JLT Pre-Filters are now available for most intake kits we carry, these filters are made for us by Outerwears, these prefilters are water repellent. They will increase your filter life and cut down on your cleaning intervals! For more information check the product page here JLT Air Filter PRE FILTER
*This product is NOT CARB (California Air Resource Board) Exempt. It is not for legal sale or use in the state of CA or any other states adopting CA emission standards and require a CA Executive Order (EO) number.
|Dimensions||14 × 14 × 16 in|